St. George, UT Plumbing Help
A backed-up drain, a water heater that won't heat, or a running toilet you've been meaning to fix — tell us what's going on below and we'll get you matched with a local plumber who actually handles it.
Serving St. George, Washington, Ivins, Santa Clara, Hurricane · Washington County, UT
Before you call
Pick the situation closest to yours. Nothing is submitted — this only changes which answer is shown below.
General repair
Not urgent — schedule it
A dripping faucet, a toilet that runs after every flush, or a single slow drain can almost always wait for a normal appointment rather than an emergency call. Fixture installs (a new faucet, a garbage disposal, a toilet swap) fall here too.
Emergency
Stop using drains — call now
If it's a single drain, stop using that fixture. If multiple drains or toilets are backing up at the same time, stop using every drain in the house — that usually points to a blockage in your own main line, not just one fixture, and is worth same-day attention. A plumber can also tell you if what you're seeing looks like a public sewer-main issue rather than your own line — in St. George itself that's the St. George Wastewater Treatment Division; Hurricane, La Verkin, and Toquerville are served by the Ash Creek Special Service District instead (WC-002).
Water heater
Check the basics, then get it looked at
Check the breaker or pilot light first. If the tank itself is leaking, shut off the water supply to the heater and get it looked at the same day. St. George's water runs hard — 342 ppm (20 grains per gallon, WC-004) — and sediment buildup from that hardness is one of the most common reasons a water heater here fails earlier than it should.
Slab leak
Worth a professional check soon
A warm spot on the floor, a water bill that jumped with no obvious reason, or hearing water run when every fixture is off are the classic slab-leak warning signs. It's rarely a same-hour emergency, but the longer a slab leak runs the more it can damage — get it checked soon rather than waiting.
Just comparing prices? See the full St. George plumbing cost guide.
No. St. George Plumber Pro is a referral service — we connect you with independent, licensed local plumbing contractors. We do not perform plumbing work ourselves, and we don't handle new-construction or remodel plumbing.
Utah's Division of Professional Licensing (DOPL) licenses plumbing contractors. Always ask a matched provider for their license number and verify it yourself using DOPL's free public lookup tool at secure.utah.gov/llv before hiring — see our step-by-step license verification guide for exactly how.
It depends on the job — general repairs typically run $100–$535, drain cleaning $200–$1,400, water heater replacement $882–$3,900, and slab leak detection and repair $630–$4,400, based on national plumbing cost data as of September 2026. Our full plumbing cost guide has the sourced, dated breakdown for every job.
Sewage backing up, multiple drains or toilets backing up at the same time, or a pipe actively spraying water are true emergencies — stop using your plumbing and get help the same day. A single slow drain or a dripping faucet can almost always wait for a normal appointment. The situation picker above walks through the most common cases.
We compare real local companies honestly on our best licensed plumbers page — no invented ratings, no sponsored placement. Or skip the research and get matched directly with whoever has capacity for your specific situation.
Tell us what's going on and your city — we'll connect you with an independent, licensed local plumber who covers it.
Form opens at launch — this preview shows the fields and consent language as built.